lordpil's blog


assemblers will usually do it faster unless its too hack

Posted by renesis at 22:18 | permalink | 0 comments


cheater__: welcome to r&d rework?
you just do it
you rear the circuit, stare at the layout, figure out how to use existing pads if possible
then go nuts cutting traces, standing smd on end and on top of each other, connecting shit up with bus wire
get someone else to double check it, if you can
after staring at it so long, itll be more difficult to do it on your own, because usually a weird 3d hack that can be hard to visualize as a 2d schematic
kind of what seperates a lab tech from an assembler. the tech should be able to design the rework

Posted by renesis at 22:13 | permalink | 0 comments


Top | Add to Technorati Favorites


© 2007 lordpil.   XHTML 1.0! CSS! Site design by GNAA  Blog Engine by pbx | MULTI2 | ian hanschen | lolwat